MacDon D1X Series - Installing Crop Dividers Without Latch Option Onto Header

215651 73 Revision B

&
'
%
$
Figure 3.43: Crop Divider
7. Position the crop divider as shown by inserting lugs (A) into
the holes in the endsheet.
8. Lift the forward end of the crop divider until pin (B) at top
of the crop divider engages and closes latch (C).
9. Push safety lever (D) downwards to lock the pin into
latch (C).

$
Figure 3.44: Crop Divider
10. Pull the tip of the crop divider to ensure there is no lateral
movement. If necessary, adjust bolts (A) to tighten the crop
divider and eliminate any lateral movement.
11. Close the endshield. For instructions, refer to Closing
Endshields, page 38 .
Installing Crop Dividers without Latch Option onto Header
To correctly install crop dividers without the latch option, follow the recommended installation procedure provided here.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine,
remove the key, and engage the safety props before going under the header for any reason.
1. Lower the reel fully. For instructions, refer to your windrower operator’s manual.
2. Raise the header fully. For instructions, refer to your windrower operator’s manual.
3. Shut down the engine, and remove the key from the ignition.
4. Engage the safety props. For instructions, refer to your windrower operator’s manual.
OPERATION