215651 207 Revision B
Figure 5.176: Removing Plastic Finger
5. Remove screw (A) using a Torx
®
Plus 27 IP socket wrench.
Figure 5.177: Removing Plastic Finger
6. Push the clip at the top of the finger back towards the reel
tube as shown and remove the finger from the tube.
Installing Plastic Fingers
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator’s seat for any reason.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
NOTE:
This procedure assumes a finger has been removed from the machine. For information about removing fingers, refer to
Removing Plastic Fingers, page 206.
MAINTENANCE AND SERVICING
To Next Page
Loading...
