MacDon D1X Series - Replacing Reel Endshield Supports

215651 223 Revision B

$%
&
'($
Figure 5.219: Reel Endshields
10. Reinstall bolts (A).
11. Tighten all hardware.
Replacing Reel Endshield Supports
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator’s seat for any reason.
1. Lower the header fully.
2. Lower the reel fully.
3. Shut down the engine, and remove the key from the ignition.

$
%
&
Figure 5.220: Reel Endshield Supports
4. Rotate the reel manually until the reel endshield support
requiring replacement is accessible.
5. Remove bolt (B) from support (A).
6. Remove bolts (C) from support (A) and two adjacent
supports.
MAINTENANCE AND SERVICING