MacDon D1X Series - Closing Endshields

215651 38 Revision B

$
%
&
Figure 3.8: Left Endshield
4. Pull the endshield at handle depression (A).
NOTE:
The endshield is retained by hinge tab (B) and will open in
direction (C).

$
%
Figure 3.9: Left Endshield
5. If additional clearance is required, pull the endshield free of
hinge tab (A) and swing the endshield toward the rear of
the header.
6. Engage safety latch (B) on the hinge arm to secure the
endshield in the fully open position.
Closing Endshields
Close and lock the endshields before moving the header.

$
%
Figure 3.10: Left Endshield
1. Disengage latch (B) to allow the endshield to move.
2. Insert the front of the endshield behind hinge tab (A) and
into the divider cone.
OPERATION