215651 239 Revision B
5.10 Transport System (Option)
Refer to 6.3.4 Stabilizer Wheels and Transport Package, page 250 for more information.
5.10.1 Checking Wheel Bolt Torque
If a transport system is installed, follow these steps to torque the wheel bolts. Wheel bolt torque should be checked 1 hour
after installation and every 100 hours thereafter.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key before making adjustments to the machine.
1. Shut down the engine, and remove the key from the ignition.
Figure 5.255: Bolt Tightening Sequence
2. Follow the bolt tightening sequence shown, and torque the
wheel bolts to 110–120 Nm (80–90 lbf∙ft).
IMPORTANT:
Whenever a wheel is removed and reinstalled, check the
wheel bolt torque after 1 hour of operation and every 100
hours thereafter.
5.10.2 Checking Axle Bolt Torque
If a transport system is installed, do the following steps to torque the axle bolts:
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key before making adjustments to the machine.
MAINTENANCE AND SERVICING
To Next Page
Loading...
