215651 267 Revision B
Problem Solution
Refer to
Drapers running too fast in light crop Reduce draper speed 3.7.6 Draper Speed, page 66
Symptom: Material accumulates inside or under front edge of draper
Deck height improperly adjusted Adjust deck height 5.7.5 Adjusting Deck Height, page 181
Symptom: Material accumulating on end deflectors and releasing in bunches
End deflectors too wide
For headers with manual deck shift
only, trim deflector or replace with
narrow deflector (MD #172381)
3.13 Unplugging the Cutterbar, page
85
TROUBLESHOOTING
To Next Page
Loading...
