MacDon R85 - Page 185

214366 168 Revision A
1006443
A
B
Figure 5.67: Auger Drive Belts
6. Loosen jam nut (A) to release tension on auger drive
belts (B).
7. Remove all three belts.
1007459
A
B
Figure 5.68: Auger Drive Belts
8. Install belts (A) on the pulleys. Ensure they are seated
the pulley grooves.
9. Check alignment of belts on pulleys. Belts must not
overhang the edge of idler pulley (B). Contact your
MacDon Dealer if pulleys need realigning.
1006443
A
B
Figure 5.69: Auger Drive Belts
10. Tension the belts (B) with adjuster nuts (A). Refer to
Inspecting and Adjusting the Auger Drive Belts, page
166.
MAINTENANCE AND SERVICING