214366 11 Revision A
1.8 Understanding Safety Signs
1000917
Figure 1.20: MD #113482
MD #113482
General hazard pertaining to machine operation and
servicing
CAUTION
To avoid injury or death from improper or unsafe machine
operation:
• Read the operator’s manual and follow all safety
instructions.
• Do not allow untrained persons to operate the machine.
• Review safety instructions with all Operators every year.
• Ensure that all safety signs are installed and legible.
• Make certain everyone is clear of machine before starting
engine and during operation.
• Keep riders off the machine.
• Keep all shields in place and stay clear of moving parts.
• Disengage header drive, put transmission in Neutral, and wait for all movement to stop before leaving
operator’s position.
• Stop the engine and remove the key before servicing, adjusting, lubricating, cleaning, or unplugging machine.
• Engage safety props to prevent lowering of header or reel before servicing in the raised position.
• Use slow moving vehicle emblem and flashing warning lights when operating on roadways unless prohibited
by law.
1000706
Figure 1.21: MD #166466
MD #166466
High pressure oil hazard
WARNING
• Do not go near leaks.
• High pressure oil easily punctures skin causing serious
injury, gangrene, or death.
• If injured, seek emergency medical help. Immediate
surgery is required to remove oil.
• Do not use finger or skin to check for leaks.
• Lower load or relieve hydraulic pressure before loosening
fittings.
SAFETY
To Next Page
Loading...
