IMPULSE
®
•G+ & VG+ Series 4 Technical Manual
November 2020
Page 191
U01-60 PG CH1 Count Displays the raw PG Channel 1 pulse count
4 pulses = 1 ppr of F01-01
Pulses
U01-61 PG CH2 Count Displays the raw PG Channel 2 pulse count
4 pulses = 1 ppr of F01-01
Pulses
U01-63 PG CH1 Freq Displays the current input frequency on PG Channel 1 Hz
U01-64 PG CH2 Freq Displays the current input frequency on PG Channel 2 Hz
U01-65 PG Output Freq Displays the current output frequency on the PG Output channel Hz
U01-66 BE6 Pulse Count Displays the amount of shaft movement during the BE6 detection
time
4 pulses = 1 ppr of F01-01
Pulses
U01-68 LC Zone Displays the LC Zone the VFD is currently running in. If an LC fault
occurs, the value displayed will be which LC zone the LC fault
occurred in.
-
U01-69 LC Margin Displays how close the current/torque levels are to the target value
for each of the LC zones. Values less than zero will cause an LC
detection or an LC fault to occur. If the LC fault occurs, the value
displayed is the amount the level was below the LC zone setting.
%
U01-84 NLB State Displays the current NLB State Machine sequence.
Analog Output Level: 0.5V/State
-
U01-85 NLB Rel Trq Torque level for next BE2 check. Is set to 100% after BE2 is passed,
and set to torque output level at end of Load Float. No signal output
available
%
U01-86 Brk Test Trq Brake breakaway torque; FLV only; MFDI needs to be programmed
with “Brake Test”
Flb
Parameter Display Function Units
To Next Page
Loading...
Need help?
General
