Magnetek IMPULSE G+ 4 Series User Manual

IMPULSE
®
•G+ & VG+ Series 4 Technical Manual
November 2020
Page 244
* Initial value set by X-Press Programming (Table 4-6 on page 59, Table 4-7 on page 60 and Table 4-8 on page 61).
** Initial value dependent on VFD size, which is determined by O02-04 (kVA Selection).
*** Value is automatically set during auto tuning.
**** 0.0–25.5 seconds is extended to 0.0–6000.0 seconds when B05-16 = 1.
U04-01 Drv Elapsed Time - - hr Page 194
U04-03 Fan Elapsed Time - - hr Page 194
U04-04 Fan Life Mon - - % Page 194
U04-05 Cap Life Mon - - % Page 194
U04-06 ChgCirc Life Mon - - % Page 194
U04-07 IGBT Life Mon - - % Page 194
U04-08 Heatsink Temp - - °C Page 194
U04-09 LED Oper Check - - - Page 194
U04-10 kWh Lower 4 dig - - kWh Page 194
U04-11 kWh Upper 5 dig - - MWh Page 194
U04-12 CPU Occup Rate - - % Page 194
U04-13 Current PeakHold - - A Page 194
U04-14 Freq@ I PeakHold - - Hz Page 194
U04-16 Motor OL1 Level - - % Page 194
U04-17 Drive OL2 Level - - % Page 194
U04-18 Reference Sou rce - - - Page 194
U04-19 MEMOBUS Freq Ref - - % Page 194
U04-20 Option Freq Ref - - % Page 194
U04-21 Run Cmd Source - - - Page 194
U04-22 MEMOBUS Ref Reg - - - Page 194
U04-23 Option Ref Reg - - - Page 194
U04-32 Motor Temp (NTC) - - - Page 194
U04-37 OH Alarm Axis - - BIN Page 194
U04-38 FAN Alarm Axis - - BIN Page 194
U04-39 VOF Alarm Axis - - BIN Page 194
U06-01 Mot SEC Current - - % Page 195
U06-02 Mot EXC Current - - % Page 195
U06-03 ASR Input - - % Page 195
U06-04 ASR Output - - % Page 195
U06-05 Voltage Ref (Vq) - - VAC Page 195
U06-06 Voltage Ref (Vd) - - VAC Page 195
U06-07 ACR(q) Output - - % Page 195
U06-08 ACR(d) Output - - % Page 195
U06-18 PG1 CounterValue - - PPR Page 195
U06-19 PG2 CounterValue - - PPR Page 195
U06-22 Zero Servo Pulse - - Pulse Page 195
U06-26 FF Cont Output - - % Page 195
Parameter Parameter Name Default Range Units Reference

Magnetek IMPULSE G+ 4 Series Specifications

General

Brand	Magnetek
Model	IMPULSE G+ 4 Series
Category	DC Drives
Language	English