2-3
Washer
Always Do The Following To Maintain
Washer Freshness:
n Use only “HE” High Efficiency detergent.
n Leave the door slightly open after each
cycle to allow for better ventilation and
drying of washer interior.
n Clean the washer monthly (see “To clean
washer interior”), using 160 mL (2/3 cup) of
liquid chlorine bleach.
n If the procedure does not sufficiently
improve the washer freshness, please
evaluate the installation and usage
conditions for other causes.
Cleaning The Exterior
Use a soft damp cloth or sponge to wipe up
any spills. Occasionally wipe the outside of the
washer to keep it looking new. Use mild soap
and water. Do not use abrasive products.
Cleaning The Dispenser Drawer
The dispenser drawer is removable for easy
cleaning.
1. Unlock the dispenser drawer for removal
by inserting a flat-blade screwdriver into
the catch release. Remove the dispenser
drawer.
2. Remove the inserts (the siphon from the
softener and bleach compartments).
3. Wash the parts under running water.
NOTE: Do not wash components in the
dishwasher.
4. Reinstall the inserts and return the
dispenser to the drawer.
sensing cycle. This will take approximately
3 minutes.
4. The cycle will determine whether clothing or
other items are in the washer.
a) If no items are detected in the washer, it
will proceed to Step 7.
b) If any items are detected in the washer,
“F-34” will be displayed. Then the door will
unlock.
n Enter the service mode. Press and hold
the Delicates keypad until P01 is displayed.
Then press Start - All segments of the
display will flash. This will clear current Fault
5. Once the cycle has begun, allow the cycle
to complete.
6. After the cycle is complete, leave the door
open slightly to allow for better ventilation
and drying of washer interior.
To Next Page
Loading...
