4-72
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Remove the drive belt (See page 4-70).
3. Press the locking tab and pull one earth
wire connector off the spade.
4. Disconnect the other earth wire from the
motor by pulling it off the spade connector.
5. Cut the wire tie securing the motor wire
harness and earth wires.
6. Press the locking tabs and disconnect the
motor wire harness plug.
MOTOR
7. Remove the 13mm (1/2“) bolt securing the
motor to the outer tub.
8. Rotate the motor down and slide the
mounting posts out of the holes of the tub by
rocking the motor up and down while pulling
it away from the washer.
13mm Motor Bolt
Wire Tie
Motor Wire
Harness Plug
Earth Wires
Mounting Posts
To Next Page
Loading...
