2-2
Maintenance Instructions:
This washer has a special cycle that uses
higher water volumes in combination with
liquid chlorine bleach to thoroughly clean the
inside of the washer.
NOTES:
n Read these instructions completely before
beginning the cleaning process.
To Clean Washer Interior:
1. Open the washer door and remove any
clothing or items from the washer.
Use Liquid Chlorine Bleach:
Open the dispenser drawer and immediately
add 160 mL (2/3 cup) of liquid chlorine
bleach to the bleach compartment.
NOTE: Do not add any detergent. Use of
more than 160 mL (2/3 cup) of bleach will
cause product damage over time.
2. Close the washer door and the dispenser
drawer.
3. To start the Washer Cleanout cycle, rst
enter “Service Mode.” Press and hold the
Delicates keypad until P01 is displayed.
Press Extra Rinse to advance to P08 then
press Start.
NOTE: The door will lock, the basket will
rotate 1/2 turn, then the door will unlock and
lock again, then the Washer Cleanout Cycle
will continue.
n The washer will not fill, but the basket
will rotate while the washer runs a short
MAINTENANCE INSTRUCTIONS
Washer
Cleaning The Door Seal/Bellow
1. Open the washer door and remove any
clothing or items from the washer.
2. Inspect inner glass door. If debris is
present, wipe it off using a damp cloth.
3. Inspect the colored seal/bellow between
the door opening and the basket for stained
areas. Pull back the seal/bellow to inspect
all areas under the seal/bellow and to check
for foreign objects.
4. If stained areas are found, wipe down these
areas of the seal/bellow:
a) Mix a dilute solution, using 177 mL
(3/4 cup) of liquid chlorine bleach, and
3.8 L (1 gal.) of warm tap water.
b) Wipe the seal/bellow area with the dilute
solution, using a damp cloth.
c) Let stand 5 minutes.
d) Wipe down area thoroughly with a dry
cloth and let the washer interior air dry with
door open.
IMPORTANT:
n Refer to the bleach manufacturer’s
instructions for proper use.
Seal/bellow
To Next Page
Loading...
