4-65
7. Unscrew the pump filter and pull it out of the
pump. If necessary, use a pair of pliers to
loosen it.
8. Move the wires down to release them from
the clip on the front of the pump motor.
9. Flip open the lid on the right end of the
pump motor to access the wire connector.
10. Press the locking tab and disconnect the
wire connector from the pump motor.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the toe panel (See page 4-61).
4. Place a towel or shallow pan below the
pump to catch any water that may be left in
the system.
5. TECH TIP: If water is seen in the washer,
there may be too much to catch all at one
time. Loosen the filter, but do not remove
it. Secure the filter when water reaches
a depth that is easy to carry. Dump the
collected water and return the pan to catch
the remaining water.
6. The pump has a clean out filter that allows
for removal of large objects that may have
passed from the spin basket.
DRAIN PUMP
Wire Clip
Lid
Wire Connector
To Next Page
Loading...
