McHale Fusion 2 troubleshooting section
14-1
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
14. Trouble Shooting
14.1 Trouble shooting overview
This section has been compiled by McHale Service Personnel in conjunction
with McHale Importers and Dealers.
It outlines some common problems which can occur and acts as a quick
reference section or check list to get to the bottom of the problem. It is
important to note that it outlines the common problems and to this effect it is
not exhaustive.
Should you experience additional problems which you need help with please
do not hesitate to contact your McHale Importer.
If you feel that any areas should be added to this section for future editions,
please email suggestions to sales@mchale.net. Your feedback is invaluable!
Thank you in advance for your help.
14.2 Machine using higher than expected horse power when chopping
14.3 Pick up slip clutch going off easily
Reason Solution Reference Section
Knives
in chopper unit are
blunt
Remove the blades and
sharpen and replace
7.7
Reason Solution Reference Section
Pick up set too close
the ground
Adjust the pick up to a
higher position. Tines
should not be getting
caught in the ground.
9.3
Pick up chains loose Tighten the pick up
chains and check as
specified.
10.6.5
10.6.6
To Next Page
Loading...
