McHale Fusion 2 - Rotor Slip Clutch Disengaging Easily; Knives Not Remaining Up While Chopping

McHale Fusion 2 troubleshooting section
14-2
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
14.4 Rotor slip clutch going off easily
14.5 Knives not remaining up while chopping
Reason Solution Reference Section
Rotor chain loose and
slips thus causing the
slip clutch to go off
Tighten the rotor chain
and check as specified
10.6.7
Poor swarth
preparation
Prepare the swarth in
line with the
recommendations in
the machine set up
section
9.2
Knives blunt Check and sharpen if
needed
7.7
Slip clutch setting
incorrect
Check and recalibrate if
needed
13.7
Reason Solution Reference Section
Knives not turned on in
the control box.
Ensure the knives are
turned on.
11.6.3
Dirt in the knife
pressure adjustment
valve.
Remove, clean, replace
and reset/ re-calibrate
12.8.2
Knife Pressure set too
low
Check the pressure
clock and reset if nec-
essary
12.8
Weak Accumulator Test and replace
accumulator if
necessary
12.7.4
Solenoid Sticking Refit or replace 11.5.4