McHale Fusion 2 - Net Feed Issues During Automatic Cycle; Incorrect Net Cutting or Tension

McHale Fusion 2 troubleshooting section
14-4
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
Reason Solution Reference Section
Oil Leak Find Leak and resolve
Seals gone in door ram Test both rams and
identify leaking ram and
replace seals
Copper Washer inside
door cartridge in door
ram leaking
Remove cartridge and
replace copper washer
Faulty Door Valve Replace Valve
14.8 Net will not feed during an automatic cycle
14.9 Net not cut correctly
Reason Solution Reference Section
Box in manual Press net button for 3
seconds and switch the
box to auto
11.6.1
Netter knife not reset Reset netter knife 7.5
Tension springs too
slack/ too loose
Adjust springs Located behind the
netter drive gears
Clutch not activating to
release the tension
Find the fault and
rectify
11.2.1
Reason Solution Reference Section
Net tension is too loose
as it passes into the
netter
Adjust net tension
system
7.4
Not enough tension on
the net roll in the net
box
Remove any crop build
up around the spring-
Check the tension
springs/ adjust or
replace if necessary
Located on the front of
the net box
Blunt/ rusty knife Fit new knife 7.5
Grease on Knife (new
machine/ machine after
winter storage)
Clean grease off knife
Knife spring too slack Adjust knife spring
pressure
Located behind the
netter drive gears