McHale Fusion 2 - Net Feeding Incorrectly into Bale; Bale Door Not Opening After Netting

McHale Fusion 2 troubleshooting section
14-5
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
14.10 Net feeds in, in the middle of a bale
14.11 Netting process complete but the bale door will not open
Reason Solution Reference Section
Net not cut correctly on
previous bale (machine
setting)
Check knife
Check spring tension
7.5
Spring is located on the
the drive side of the
machine behind the
netter gears.
Not enough tension on
net roll in net box
Check the tension
springs/ adjust or
replace if necessary
Located on the front of
the net box
Faulty door proximity
sensor. Intermittent sig-
nal
Check or replace sen-
sor
11.2.6
11.4.2
Reason Solution Reference Section
Box in manual Switch the box into auto
and press the top door
button
11.6.1
Net knife sensor not
working/ magnet
missing (damaged).
Net error will be
displayed after 20
seconds
Conduct visual
inspection/ input check
and replace if
necessary
11.2.9
11.4.1
11.8
The netter sensor is too
far from the magnet. In
the case the magnet
may see the sensor for
a second and then not
see it. If the netter
sensor does not remain
closed then the doors
will not open. (no net
error)
Move the sensor closer
to the magnet.
Conduct input output
test on the netter
sensor.
11.2.9
11.4.1
11.8
Bale on back of the
machine has not tipped
Tip bale 11.6.1
Dispensers have
moved out of line
Index the dispensers
from the control box
11.6.3
Auto- (button 13)