McHale Fusion 2 - Wrapper Not Starting After Bale Transfer; Wrapper Ring Rotation Failure

McHale Fusion 2 troubleshooting section
14-7
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
14.14 Wrapper will not start after bale transfer
14.15 Ring will not rotate even though the motors are rotating
Reason Solution Reference Section
Chamber full sensor is
not closed
Check for crop build up/
Conduct an input output
test
11.2.6
11.8
Chamber door sensor
not seeing door closed
Check door is closing
and proximity sensor
operation
11.4.2
Sensor on tip roller is
not closed “safety
switch error”
move up the back roller
from the control box
(box in manual)
11.4.1
11.6
Dispenser access door
is not closed “safety
switch error”
Securely close the door
and apply rubber latch
3
Reason Solution Reference Section
Brake on Check brake ram and
adjust if necessary
10.4.3
10.4.4
12.5
Dirt build up on motor
mounts which drive the
ring
Clean and power wash
down
The dispenser ring is
driven by two motors at
the bottom
Torque tensioners have
been adjusted
incorrectly and are too
loose
Re-adjust