McHale Fusion 2 - Film Break Error Troubleshooting; Dispenser Breaking Plastic Film

McHale Fusion 2 troubleshooting section
14-8
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
14.16 Film break error when the film is not broken or run out
14.17 Dispenser breaking plastic
Reason Solution Reference Section
Magnet missing/
damaged
Remove dispenser cap,
check and replace if
necessary
11.2
11.2.11
Receiver not picking up
signal
Check for power to the
receiver programme the
receiver
11.2
11.2.11
Battery flat in
transmitter
Replace cap and
re-programme the
receiver
11.2
11.2.11
Faulty receiver Replace the receiver 11.2
11.2.11
Two caps which are
odd or even
Change one of the caps
and re-programme
11.2
11.2.11
Reason Solution Reference Section
Foreign/ crop build up
between the rollers and
the plastic
Clean any foreign
material away from the
dispenser rollers
Rollers are dirty from
tack build up
Clean down rollers
using mentholated
spirits and power wash
down
10.5
Tight spot in dispenser Re-adjust the bearing
so the tight spot is
removed
Dispenser frame has
bent net and the
bearing alignment is off
as a result
Replace frame and any
damaged bearings
Poor quality plastic Source plastic of a
better quality