McHale Fusion 2 - Cut and Hold Not Extending Fully; Cut and Hold Not Cutting Film Cleanly; Cut and Hold Releasing Prematurely

McHale Fusion 2 troubleshooting section
14-9
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
14.18 Cut and hold not going out all the way
14.19 Cut and hold not cutting clean
14.20 Cut and hold releasing while the machine is baling
Reason Solution Reference Section
Blade rusty/ broken Replace blade 8.5
Tack/ rust build up on
rails
Clean/ replace rails 10.5.2
Blade adjustment
incorrect
Adjust blade holder 8.5
Bearing broken/ not set
correctly on rails
Adjust or replace 8.5.
Reason Solution Reference Section
Machine was
previously fitted to a
tractor with higher
pressure than the
current tractor and as a
result the accumulator
is over primed
Drain some of the oil
from the accumulator
and work the machine.
(the accumulator is self
priming)
Warning
accumulators contain
high pressure oil at
all times
Bearing tight/ damaged
and getting caught on
the rail
Check bearing and ad-
just or replace if
needed
8.5
Reason Solution Reference Section
High back pressure
(faulty quick release/
poor return)
Check return line
pressure and hydraulic
couplings ensure that a
parker quick release is
in place if 1/2” fittings
are being used.
6.10
Seals gone in cut and
hold ram
Replace the ram seals 8.5