Control Step / Description Control
Action
Display
Step 7a
Press the ENTER key again. If the password has been
re-entered correctly, the LED indicator labeled EDIT
MODE goes out and the display appears as shown on
the right. The new Password is now valid.
Par/Conf/LOC
Password
********
Step 7b If the password has been re-entered incorrectly, the
LED indicator labeled EDIT MODE remains on and the
display shown on the right appears. The password has
to be re-entered. It is also possible to cancel the
change of the Password by pressing the CLEAR key (see
Step 8).
Par/Conf/LOC
Password
**
_
Step 8
The change in password can be canceled at any time
before Step 7 by pressing the CLEAR key. If this is
done, the original Password continues to be valid.
Par/Conf/LOC
Password
********
6.11.9.2 Local Control Panel without Password Protection
Operation from the local control panel without password protection is also
possible. To select this option, immediately press the ENTER key a second time in
steps 4 and 6 of Table, (p. 6-32), without entering anything else. This will
configure the local control panel without password protection, and no control
actions involving changes will be possible until the global change-enabling
function has been activated (see “Change-Enabling Function”, Section 6.11.3,
(p. 6-18)).
6 Local Control (HMI) P634
P634/EN M/R-42-A // P634‑311‑653 6-33
To Next Page
Loading...
