Parameter Address
Default Min Max Unit Logic Diagram
[spacer]
PC: IP address 1
111 005
168 0 255
[spacer]
PC: IP address 2
111 006
1 0 255
[spacer]
PC: IP address 3
111 007
2 0 255
[spacer]
IP address of the Ethernet interface of the P634's processor module.
This is the Ethernet interface of the processor module and can be used for
special service activities, e.g. for uploading new firmware.
Note: In the operating program, the complete IP address is displayed at PC: IP
address. The device’s front panel display only displays the IP address
distributed to these four data model addresses:
●
PC: IP address,
●
PC: IP address 1,
●
PC: IP address 2,
●
PC: IP address 3.
Note: This interface can only be used if it has been configured (PC: IP
address, PC: Subnet mask, PC: IP address mode) and activated via
PC: IP Enable config..
[spacer]
PC: Subnet mask
111 008
255 0 255
[spacer]
PC: Subnet mask 1
111 009
255 0 255
[spacer]
PC: Subnet mask 2
111 010
255 0 255
[spacer]
PC: Subnet mask 3
111 011
0 0 255
[spacer]
Subnet mask of the Ethernet interface of the processor module.
Note: In the operating program, the complete mask is displayed at
PC: Subnet mask. The device’s front panel display only displays the mask
distributed to these four data model addresses:
●
PC: Subnet mask,
●
PC: Subnet mask 1,
●
PC: Subnet mask 2,
●
PC: Subnet mask 3.
7 Settings P634
P634/EN M/R-42-A // P634‑311‑653 7-15
To Next Page
Loading...
