Micom P634 - Page 747

Parameter Address
[spacer]
SFMON: Invalid scaling A-2
093 115
[spacer]
An invalid characteristic has been set for one of the analog output channels of
analog I/O module Y.
Device reaction: Depends on type of fault detected.
“Warning” output relay: Updating
“Blocked/faulty” output relay: –
[spacer]
SFMON: Invalid scaling IDC
093 116
[spacer]
An invalid characteristic has been set for the analog input channel of analog I/O
module Y.
Device reaction: Depends on type of fault detected.
“Warning” output relay: Updating
“Blocked/faulty” output relay: –
[spacer]
SFMON: PT100 open circuit
098 024
[spacer]
The P634 has detected an open circuit in the connection of the resistance
thermometer “PT100” to the analog I/O module Y.
Device reaction: Depends on type of fault detected.
“Warning” output relay: Updating
“Blocked/faulty” output relay: –
[spacer]
SFMON: Overload 20 mA input
098 025
[spacer]
The 20 mA input of analog I/O module Y is overloaded.
Device reaction: Depends on type of fault detected.
“Warning” output relay: Updating
“Blocked/faulty” output relay: –
[spacer]
SFMON: Open circ. 20mA inp.
098 026
[spacer]
The P634 has detected an open circuit in the connection of the 20 mA input.
Device reaction: Depends on type of fault detected.
“Warning” output relay: Updating
“Blocked/faulty” output relay: –
[spacer]
SFMON: Setting error f<>
098 028
[spacer]
The over-/underfrequency protection function has been set for “overfrequency”
monitoring (based on the settings for operate value and nominal frequency).
This setting is not valid in the f w. Delta f/Delta t operating mode.
Device reaction: Blocking of the over-/under frequency protection function
“Warning” output relay: Updating
“Blocked/faulty” output relay: –
[spacer]
SFMON: Iref, a inval. range
091 007
[spacer]
SFMON: Iref, b inval. range
091 008
[spacer]
SFMON: Iref, c inval. range
091 009
11 Troubleshooting P634
P634/EN M/R-42-A // P634‑311‑653 11-13