Version Changes
COMM1,
COMM2
The menu points (003 161) COMM1: Name of
manufacturer and (103 161) COMM2: Name of
manufacturer can no longer be set by using a
selection list but, for reasons of compatibility, they may
now be defined as free text. The default is SE but, in
individual cases, it may become necessary to enter
texts differing from the default.
Notes:
●
These parameters can only be set using the
operating program and it is not possible to set
them locally using the integrated local control
panel (HMI). The maximum text length is 8
characters and designations exceeding this will
be truncated.
●
The parameter COMM1: Name of
manufacturer is hidden unless an IEC 60870-5
protocol is enabled.
IEC
Bug fixing:
●
The implementation of the IEC 61850 signals
RBRFn and the IEC 61850 modeling of I
N
in the
Logical Nodes MMXU and MSQ has been modified
so that it matches other MiCOM Px3x protection
devices.
LED, MAIN, ... The English designation text of the following data point
has been changed, but functionality remains
unchanged. The old designation is shown on the left
and the new designation on the right-hand side.
CTS: Reset latching EXT → CTS: Reset latch.
EXT
DVICE The new data point (008 233) DVICE: SW
vers.Chin.DHMI DM is a purely internal version
number (for the order option “Chinese display”).
Bug fixing:
●
Display problems with the Fault Panel are
resolved.
V/f The setting range for V/f: t at V/f=1.05 PSx has
been extended:
●
Previously: 1.0 s to 1000.0 s in steps of 0.1 s,
●
Now: 1.0 s to 6000.0 s in steps of 0.1 s.
Similarly, the setting range for V/f: Reset time PSx
has been extended:
●
Previously: 0 s to 10000 s in steps of 1 s,
●
Now: 0 s to 60000 s in steps of 1 s.
P634 Hardware
P634 A5 P634 Version History
A5-26 P634/EN M/R-42-A // P634‑311‑653
To Next Page
Loading...
