Micros Systems PCWS 2015 - Turing the Workstation from NOPOWER to on

PCWS 2015 Setup Guide - 2nd Edition 4-13
Installing and Operating the Workstation 2015
Operation
Turning the Workstation from NOPOWER to ON
See Chapter 1 for a description of the supported power management states.
When the PCWS 2015 is in the NOPOWER state, the Operator LCD will be
blank and the Operator LED is off.
1. Be sure the AC Power Cable is connected to an AC source.
2. Press the power button, then release it.
• The CPU Fan should start running at full speed.
• The Operator LED starts flashing green.
• After several seconds, a progress bar appears in the lower right corner
of the screen, then the BIOS Splash Screen /w MICROS logo appears.
• If RAID is enabled, the Intel Rapid Storage Technology Option
ROM displays the current status of the array. Pressing [CNTRL-I]
at this point allows you to enter the RAID configuration utility.
3. To enter the Phoenix SecureCore Tiano Setup utility, press [F2] as soon as
the BIOS Splash Screen appears. See Chapter 2 for more information about
configuring and using the PCWS 2015 BIOS.
Figure 4-7: PCWS 2015 BIOS Splash Screen Example
• The MICROS BIOS Version is displayed in the upper left corner of the
splash screen.
• After the Intel ME and perhaps the Intel AMT text prompts, the screen
clears and operating system starts.
4. If the workstation is new ‘out-of-the-box’ or the OS image newly restored,
you must enter site specific information such as the workstation name,
location, login name/password, time zone, preferences, etc.