Micros Systems PCWS 2015 - PCWS 2015 Power Management Table

PCWS 2015 Setup Guide - 2nd Edition 1-17
What is the PCWS 2015
Power Management States
The default setting of ‘Last State’ means that if the workstation is ON and AC
power fails, it returns to ON when AC power is restored with no action required
by the operator. See Chapter 3 for more information.
PCWS 2015 Power Management State Table
Figure 1-9: PCWS 2015 Power Management States
Current State Event Source Scenario New State
1 UNPLUGGED AC Power AC Power becomes
available and the last
recorded state was not the
ON state.
NOPOWER
2 NOPOWER Operator The operator presses the
power button for less than 1
seconds.
ON
3 NOPOWER Operator The operator presses the
power button for more than
4 seconds.
ON
4 NOPOWER Server
Application
A server application sends a
‘Wake On LAN’ command.
ON
5ON Operator The operator presses the
power button for more than
4 seconds.
NOPOWER
6ON Application The application shuts down
the workstation.
NOPOWER
7ON Server
Application
A server application sends a
“Wake On LAN” command.
ON
8ON Application Warm boot is called by the
CAL.
NOPOWER
then ON
9 NOPOWER AC Power
Failure
AC Power fails and restored NOPOWER
10 ON AC Power
Failure
AC Power fails and is
restored
ON