Microsens MS400870M Series User Manual

16
history command.
logout
While in User
mode, enter
logout command.
Username:
Logout
ping
While in User
mode, enter the
ping command
and followed by
target IP.
Console>
The ping test from
the Managed Switch
to another network
unit.
show
While in User
mode, enter the
show command or
enter the show
command and
followed by the
command you
would like to
view its current
setting.
Console>
Show a list of
commands or show
the current setting of
each listed
command.
Enable
Enter
Enable
mode
While in User
mode, enter the
enable command
and a password
(press Enter).
Console#
Enter Enable mode.
backup
While in Enable
mode, enter the
backup
command.
Console(backup)#
Backup configuration
file via FTP or TFTP.
cfm
While in Enable
mode, enter the
cfm command.
Console(cfm)#
Run loopback
linktrace and delay
measurement test.
configure
While in Enable
mode, enter the
configure
command.
Console(config)#
Enter Config mode.
Console
While in Enable
mode, enter the
Console
command.
Console(Console)#
Set up time-out timer
when the user is
inactive.
disable
While in Enable
mode, enter the
disable command.
Console>
Exit from current
mode.
exit
While in Enable
mode, enter the
exit command.
Console>
Exit from current
mode.
help
While in Enable
mode, enter the
help command.
Console#
Show available
commands that can
be used in Enable
mode.
history
While in Enable
Console#
List commands that

Microsens MS400870M Series Specifications

General

Brand	Microsens
Model	MS400870M Series
Category	Switch
Language	English