Microsens MS400870M Series User Manual

17
mode, enter the
history command.
have been used.
ip
While in Enable
mode, enter the ip
command.
Console(ip)#
Configure IP
addresses of the
Managed Switch.
logout
While in Enable
mode, enter the
logout command.
Username:
Logout
ping
While in Enable
mode, enter the
ping command
and followed by
target IP.
Console#
The ping test from
the Managed Switch
to another network
unit.
reboot
While in Enable
mode, enter the
reboot command.
Boot-up message
To restart the
Managed Switch.
restore
While in Enable
mode, enter the
restore command.
Console#
Load factory settings
service
While in Enable
mode, enter the
service command.
Console(service)#
Configure the
network
management
service.
syslog
While in Enable
mode, enter the
syslog command.
Console(syslog)#
Configure the Switch
syslog parameters.
system
While in Enable
mode, enter the
system command.
Console(system)#
Configure the
Managed Switch‟s
basic information.
time-server
While in Enable
mode, enter the
time-server
command.
Console(time-
server)#
Synchronize the time
of a computer client
or server to another
server.
upgrade
While in Enable
mode, enter the
upgrade
command.
Console(upgrade)#
Upgrade the
Managed Switch‟s
firmware and restore
the previous settings.
user
While in Enable
mode, enter the
user command.
Console(user)#
Configure user
accounts.
write
While in Enable
mode, enter the
write command.
Console#
Save configuration to
the Managed
Switch‟s flash
memory.
show
While in Enable
mode, enter the
show command or
enter the show
command and
followed by the
Console#
Show a list of
commands or show
the current setting of
each listed
command.

Microsens MS400870M Series Specifications

General

Brand	Microsens
Model	MS400870M Series
Category	Switch
Language	English