EasyManuals Logo

Mindray DPM 4 Operator's Manual

Mindray DPM 4
268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #252 background imageLoading...
Page #252 background image
C-8
C.2.10 CO Module Alarm Messages
Alarm message A B L Cause Measure
TB SENSOR
OFF
No Yes 3 The cable for blood pressure
measurement is disconnected
from the monitor.
Check for proper
connection of TB cable.
C.2.11 Mindray DS CO
2
Module Alarm Messages
Alarm message A B L Cause Measure
CO2 NO
WATERTRAP
No No 2 The water trap is not
properly connected or is
disconnected.
Make sure the sidestream
CO
2
water trap is firmly
connected.
CO2 SENSOR
TEMP HIGH
No No 1 The temperature of the
sensor assembly is too
high.
CO2 SENSOR
TEMP LOW
No No 1 The temperature of the
sensor assembly is too
low.
CO2 AIRWAY
PRES TOO
HIGH
No No 2 The pressure inside the
airway is too high.
CO2 AIRWAY
PRES TOO
LOW
No No 2 The pressure inside the
airway is too low.
CO2
BAROMETRIC
TOO HIGH
No No 2 The barometric pressure is
too high.
CO2
BAROMETRIC
TOO LOW
No No 2 The barometric pressure is
too low.
CO2
HARDWARE
ERROR
No No 1 AD sampling 2.5V error
CO2
HARDWARE
ERROR
No No 1 The pump malfunctions.
CO2
HARDWARE
ERROR
No No 1 The 3-way stopcock
malfunctions.
Restart the monitor if
necessary. If the problem
remains, contact our
company for repair.
CO2 SAMPLE
LINE
ABNORMAL
No No 2 The sample line is
abnormal or blocked.
Make sure the airway is not
blocked. If the problem still
exists, contact our company
for repair.
CO2
CALIBRATE
ZERO ERROR
No No 1 Zeroing failure. Restart the monitor. If the
problem still exists, contact
our company for repair.

Table of Contents

Other manuals for Mindray DPM 4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray DPM 4 and is the answer not in the manual?

Mindray DPM 4 Specifications

General IconGeneral
BrandMindray
ModelDPM 4
CategoryMedical Equipment
LanguageEnglish

Related product manuals