9-2
9.2 Trend Graph Recall
Select TREND GRAPH >> in SYSTEM MENU. The following window appears.
1. Trend cursor 2. Cursor time 3. Trend graph
4. Y-axis 5. X-axis 6. Parameters area
Figure 9-1 Trend Graph
As shown above, PARA1, PARA2 and PARA3 allow you to select a parameter from the options.
The trend graph of the selected parameter is displayed. If NIBP is selected, no trend graph is to
be displayed. Instead, the u mark indicates the systolic pressure, the t mark indicates the
diastolic pressure and the * mark indicates the mean pressure. The x-axis shows the time scale
while the y-axis shows the value scale of a parameter. The trend cursor
is used to identify a
specific time in the whole trend time, and it is displayed below the title “TREND GRAPH”. All
the parameter values measured at the time of the cursor are displayed in the parameters area.
PARA SELECT (Parameter Selection)
1. Rotate the control knob and highlight the field at the right side of PARA1, PARA2 or
PARA3.
2. Press the control knob, and a popup menu with all parameter options is opened.
3. Rotate the control knob and highlight your desired parameter, and then select it. The trend
graph of the selected parameter is displayed in the TREND GRAPH window.
1
2
3
5
6
4
To Next Page
Loading...
Need help?
General
