7-3
7.4 Waveform Recall
1. In the frozen mode, select the RECALL option in the FROZEN menu, and the option name
changes to L-RIGHT.
2. Rotate the control knob clockwise, and the frozen waveforms move to the right. At the lower
right corner of the first waveform is an arrow pointing upward. The time is indicated below
the arrow. The indication "0S" is used to mark the moment when the waveforms were
frozen.
3. With the waveforms move to the right, the time mark, in turn, changes to -1S, -2S, -3S…
4. The time mark is applied to all waveforms displayed on the screen.
5. Rotate the control knob anticlockwise, and the waveforms move to the left.
7.5 Recording Frozen Waveforms
1. Select WAVE 1, WAVE 2 and WAVE 3.
2. Select the REC option, and the recorder prints out the selected frozen waveforms and the
parameters measured at the moment when the waveforms were frozen.
3. If you set one or two waveforms to OFF, only the waveforms set to ON and corresponding
parameter values measured at the moment when the waveforms were frozen will be printed
out.
4. If WAVE 1, WAVE 2 and WAVE 3 are all set to OFF, the recorder will not print out any
waveform and will merely print out the parameters measured at the moment when the
waveforms were frozen.
5. The recording time length is identical to that of the waveforms displayed on the screen. If a
waveform is of faster sweep speed, its recording time is shorter.
6. During waveform recording, the monitor is still in frozen mode.
7. When the recording completes, you can select to record other waveforms.
8. If the recorder is not installed, selecting the REC option or pressing the RECORD key
triggers the "Recorder does not exit" message, which is displayed in the prompt information
area.
To Next Page
Loading...
Need help?
General
