69
Procedures
・ Confirmation on BCD output.
When BCD output hasn’t installed, skip to
step 10.
9
Press the key.
The load display will show “BCD”.
By pressing the key again, load display will
change to “0” and the digit of 10
0
will start to
flash on and off.
At the same time, when the display value varies
with the right keys, BCD output will vary
corresponding to it.
POL(polarity) output will not be ON at
the “−000000” display. In order to
make the POL output ON, other than
the values except “−000000” should be
set.
: Set value carry key
.
: Set value down key.
: Set value Increment key
: Set value Decrement key
To Next Page
Loading...
Need help?
General
