Minebea CSD-814B - Page 95

82
・ FUNC−37 Setting the direction for digital SW interface comparator.
(Effective when the option is installed.)
Initial value = 000000 0 = Over
1 = Under
10
0
digit = Comparator S1
10
1
digit = Comparator S2
10
2
digit = Comparator S3
10
3
digit = Comparator S4
・ FUNC−38 Setting hysteresis data width for digital switch interface.
(Effective when the option is installed.)
Initial value = 000000 000000 = Hysteresis data width OFF
Setting range : 000000 ～ 000099
Unit : 1 D
Data width for 99 D at “000099” setting
・ FUNC−39 Setting hysteresis time width for digital switch interface
(Effective when the option is installed.)
Initial value = 000000 000000 = Hysteresis time width OFF
Setting range : 000000 ～ 000099
Unit : 0.1 s
Time width for 9.9 s at “000099” setting
・ FUNC−40 Selection of operational mode for digital switch interface
(Effective when the option is installed.)
Initial value = 000000 000000 = 8 steps comparator mode
000001 = 4 steps comparator mode
・ FUNC−41 Selection of condition display at the time of digital switch interface
with 8 steps mode. (Effective when the option is installed.)
Initial value = 000000 000000 = Ineffective
000001 = Effective
※ Effective only when “000000” is set with FUNC−40.
・ FUNC−42 Lighting up/Putting off comparator setting display
Initial value = 000000 000000 = Lighting up
000001 = Putting off
・ FUNC−43 ON/OFF of “RUN” indicator in the status display section
Initial value = 000000 000000 = Turning ON
000001 = Turning OFF