Mitsubishi MELSEC Q Series

17
STARTING MULTIPLE CPU SYSTEM
17.2 Setting Parameters Added for Multiple CPU System
17.2.3 When creating new system
17 - 6
17
STARTING MULTIPLE CPU SYSTEM
18
TROUBLESHOOTINGAPPENDICESINDEX
17.2.3 When creating new systemíç1
íç1
Basic
Note17.1
Start
Start the C Controller setting utility.
Connect to the C Controller module.
(To next page)
"Points occupied by empty slot" (optional) on
<<System setting>> tab
Set the points to be occupied by one empty slot.
Default: 16 points
"No. of CPU" (setup required) on <<Multiple CPU setting>>
tab
Set the number of CPU modules to be mounted on the
main base unit in the multiple CPU system. Note 17.1
Note17.1
When the Basic model QCPU is used, do not set "4" to No of CPU since the number of
mountable CPU modules is limited up to 3.
Basic
Note17.1