17 - 11
17.2 Setting Parameters Added for Multiple CPU System
17.2.4 Reusing preset multiple CPU parameters
17
STARTING MULTIPLE CPU SYSTEM
POINT
When the multiple CPU parameters is imported and if "Online module change" is
enabled with a check mark in the source parameters, "Online module change" on
the <<Multiple CPU setting>> tab will be also check-marked on the C Controller
setting utility.
Since the C Controller module does not support online module change, take either
of the following actions if this happens.
1. On GX Developer, uncheck "Online module change" in the source
parameters, and import the multiple CPU parameters again.
2. Click the button on the <<Multiple CPU setting>> or <<I/O
assignment setting>> tab of the C Controller setting utility to return the
settings to the initial values, and set the same multiple CPU parameters with
the import source parameters again.
(From previous page)
Verify the multiple CPU setting data on the
<<Multiple CPU setting>> tab.
Check the I/O assignment setting and base setting
data on the <<I/O assignment setting>> tab.
Click the Detail setting button to display the "Detail
setting" screen.
(To next page)
Default
To Next Page
Loading...
Need help?
General
