Mitsubishi MELSEC Q Series User Manual

App - 12
Appendix 6 Parameter No. List
APPENDICES
(To next page)
Table App.14 Parameter No. List (Continued)
Parameter No. Item Utility name
1000H Timer limit setting
Low speed
High speed
1001H RUN-PAUSE contacts
RUN
PAUSE
1002H Remote reset C Controller setting utility
1003H Output mode at STOP to RUN C Controller setting utility
1004H Floating point arithmetic processing
1005H Common pointer No.
1007H Points occupied by empty slot C Controller setting utility
1008H
Interrupt program/Fixed scan program setting
System interrupt settings
Interrupt counter start No.
In Fixed scan interval (n:28 to 31)
100AH Intelligent function module setting(Interrupt event setting) C Controller setting utility
100CH Module synchronization C Controller setting utility
100DH A-PLC
100EH
Use serial communication
Transmission speed
Sum check
Transmission wait time
RUN write setting
100FH
System interrupt settings
High speed
interrupt setting
X input
1010H Y output
1011H Buffer read
1012H Buffer write
1100H File register
1101H Comment file used in a command
1102H Initial Device value
1103H File for local device
2000H Dev. point
2001H Latch(1) start/end
2002H Latch(2) start/end
2003H Local dev. start/end

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English