Mitsubishi MELSEC Q Series User Manual

APPENDICES
Appendix 6 Parameter No. List
App - 13
17
STARTING MULTIPLE CPU SYSTEM
18
TROUBLESHOOTING
APPENDICES
INDEX
(To next page)
Table App.14 Parameter No. List (Continued)
Parameter No. Item Utility name
3000H WDT (Watchdog timer) setting
System WDT setting C Controller setting utility
Initial execution monitoring time
Low speed execution monitoring time
3001H Error check
Carry out battery check
C Controller setting utilityCarry out fuse blown check
Carry out I/O module comparison
3002H
Operating mode when there is
an err.
Computation error
Expanded command error
Fuse blown
C Controller setting utility
I/O module comparison error
Intelligent module program execution
error
Memory card access error
Memory card operation error
External power supply OFF
3003H Constant scanning
3005H Breakdown history
3006H Low speed program execution time
3008H Memory check Check Program memory
4004H Detail setting H/W error time CPU operation mode C Controller setting utility
5000H Modules MELSECNET/H utility
5001H Valid module during other station access
5002H Interlink transmission parameters (Transfer Parameters for Data Link)
5003H Routing parameter MELSECNET/H utility
5NM0H
Start I/O No.
MELSECNET/H utilityNetwork No.
Total stations
5NM0H Mode MELSECNET/H utility
5NM1H Refresh parameters MELSECNET/H utility
5NM2H Network range assignment
Network range assignment
MELSECNET/H utility
Monitoring time
Specify I/O master Sta.
Specify reserved Sta.
Supplementary setting
5NM3H Station inherent parameters
5NM5H Sub-master parameters
5NMAH Common parameter 2
5NMBH
Station inherent parameters 2
Interrupt settings

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English