GDI ± On-vehicle Service
13A-104
ACCELERATOR PEDAL POSITION SENSOR
(1ST CHANNEL) CHECK
1. Disconnect the accelerator pedal position sensor
connector.
2. Measure resistance between terminal No.2 (sensor power
supply) and 1 (sensor earth) of the sensor connector.
Standard value: 3.5 ± 6.5 kΩ
3. Measure resistance between terminal No.2 (sensor power
supply) and 3 (sensor output) of the connector.
Normal condition:
Depress the accelerator
pedal slowly.
Resistance value changes in
accordance with the
accelerator pedal
depression smoothly.
4. If not within the standard value, or resistance value does
not change smoothly, replace the accelerator pedal position
sensor assembly.
NOTE
After replacement, adjust the accelerator pedal position
sensor. (Refer to P.13A-94.)
ACCELERATOR PEDAL POSITION SENSOR
(2ND CHANNEL) CHECK
1. Disconnect the accelerator pedal position sensor
connector.
2. Measure resistance between terminal No.8 (sensor power
supply) and 7 (sensor earth) of the sensor connector.
Standard value: 3.5 ± 6.5 kΩ
3. Measure resistance between terminal No.8 (sensor power
supply) and 6 (sensor output) of the connector.
Normal condition:
Depress the accelerator
pedal slowly.
Resistance value changes in
accordance with the
accelerator pedal
depression smoothly.
4. If not within the standard value, or resistance value does
not change smoothly, replace the accelerator pedal position
sensor assembly.
NOTE
After replacement, adjust the accelerator pedal position
sensor. (Refer to P.13A-94.)
Equipment
side connector
Accelerator pedal
position sensor
Accelerator
pedal arm
Equipment
side connector
Accelerator pedal
position sensor
Accelerator
pedal arm
To Next Page
Loading...
