ENGINE ELECTRICAL ± Starting System
16-18
STARTER MOTOR
INSPECTION
PINION GAP ADJUSTMENT
1. Disconnect field coil wire from M-terminal of magnetic
switch.
2. Connect a 12-volt battery between S-terminal and
M-terminal.
3. Set switch to ªONº, and pinion will move out.
Caution
This test must be performed quickly (in less than 10
seconds) to prevent coil from burning.
4. Check pinion to stopper clearance (pinion gap) with a
thickness gauge.
Standard value: 0.5 ± 2.0 mm
5. If pinion gap is out of specification, adjust by adding or
removing gaskets between magnetic switch and front
bracket.
S
Switch
Battery
Field coil wire
B
M
Stopper
Pinion gap
Pinion
To Next Page
Loading...
