Mitsubishi Pajero Pinin 1999 - Heater Unit, Blower Unit, Resister and Evaporator

HEATER, AIR CONDITIONER AND VENTILATION ±
Heater Unit, Blower Unit,
Resister and Evaporator
55-22
HEATER UNIT, BLOWER UNIT, RESISTER AND EVAPORATOR
REMOVAL AND INSTALLATION
Caution: SRS
When removing and installing the floor console assembly from vehicles equipped with SRS, do
not let it bump against the SRS-ECU or the components.
1
2
4
6
7
8
3
9
2
5
Piping connection
8
Compressor oil:
ZXL 200PG
OĆring
Heater unit and blower unit removal steps
D Discharging and Charging of
Refrigerant (Refer to P.55-10.)
D Discharging and Charging of Engine
Coolant (Refer to GROUP 14 ±
On-vehicle Service.)
D Engine Cover Removal and Installa-
tion (Refer to GROUP 11 ± Engine
Assembly.)
D Air Cleaner Assembly Removal and
Installation.
D Front Scuff Plate, Rear Scuff Plate,
Cowl Side Trim and Glove Box
Removal and Installation (Refer to
GROUP 52A ± Trims.)
D Front Seat Assembly (Driver's side)
Removal and Installation (Refer to
GROUP 52A ± Seat.)
D Shift Lever Assembly Removal and
Installation (Refer to GROUP 22 ±
Transmission Control.) <M/T>
D Selector Lever Assembly Removal
and Installation (Refer to GROUP 23
± Transmission Control.) <A/T>
D SRS±ECU (Refer to GROUP 52B.)
D Floor Carpet Removal and Installation.
1. Instrument panel assembly
(Refer to GROUP 52A.)
2. Intermediate connector
connections
3. Antenna feeder cable connection
4. DIN cable
5. Rear heater duct B
6. Rear heater duct A
7. Heater hoses connection
8. Refrigerant line connection
9. Blower unit, heater unit and deck
crossmember assembly