REAR AXLE ± Differential Carrier
27-15
DIFFERENTIAL CARRIER
REMOVAL AND INSTALLATION
Pre-removal Operation
D Differential Gear Oil Draining
D Axle Shaft Removal (Refer to P.27-11.)
D Brake Fluid Draining (Refer to GROUP 35A ±
On-vehicle Service.)
Post-installation Operation
D Brake Fluid Filling and Air Bleeding (Refer to
GROUP 35A ± On-vehicle Service.)
D Axle Shaft Installation (Refer to P.27-11.)
D Differential Gear Oil Filling (Refer to P.27-7.)
1
49 ± 59 Nm
Flange surface of axle housing
59 Nm
49 Nm
25 ± 29 Nm
2
3
φ 2 ± 3 mm
Sealant:
3M ATD Part No. 8661 or
equivalent
Section A ± A
A
A
Removal steps
AA" " AA 1. Rear propeller shaft connection
AB" 2. Differential carrier assembly
3. Vent plug
REMOVAL SERVICE POINTS
AA" REAR PROPELLER SHAFT DISCONNECTION
Make mating marks on the companion flange and the flange
yoke, and then disconnect the propeller shaft from the
companion flange.
Caution
Use a wire, etc. to suspend the propeller shaft from the
body to prevent it from falling.
To Next Page
Loading...
