MANUAL TRANSMISSION ± On-vehicle Service
22-3
TRANSFER OIL CHECK
1. Remove the oil filler plug.
2. Oil level should be at the lower portion of the oil filler
plug hole.
3. Check that the transfer oil is not noticeably dirty, and it
has a suitable viscosity.
4. Install the oil filler plug, and then tighten it to the specified
torque.
Tightening torque: 29 ± 34 Nm
TRANSFER OIL CHANGE
1. Remove the oil drain plug to drain oil.
2. Install the oil drain plug, and then tighten it to the specified
torque.
Tightening torque: 29 ± 34 Nm
3. Remove the oil filler plug, and then fill with specified oil
till the level comes to the lower portion of oil filler plug
hole.
Specified oil:
Hypoid gear oil SAE 75W ± 90 or 75W ± 85W
conforming to API GL-4
Quantity: 2.2 ȏ
4. Install the oil filler plug, and then tighten it to the specified
torque.
Specified torque: 29 ± 34 Nm
Oil level
Oil filler
plug hole
Oil filler plug
Oil drain plug
To Next Page
Loading...
