CHASSIS ELECTRICAL ± Antenna
54A-64
ANTENNA
REMOVAL AND INSTALLATION
4
5
1
3
2
Removal steps
1. Radio and tape player (Refer to
P.54-61.)
D Instrument under cover
(Refer to GROUP 52A.)
2. Cowl side trim (Refer to GROUP
52A)
AA" 3. Antenna assembly
4. Antenna base
D Instrument panel (Refer to GROUP
52A)
5. Antenna feeder
REMOVAL SERVICE POINT
AA" ANTENNA ASSEMBLY REMOVAL
Observe the following steps to make the feeder cable of
the antenna to be routed easily during reinstallation.
1. Secure a cord to the end of the feeder cable.
2. Pull out the feeder cable slightly until the tube end of
the antenna can been seen.
3. Insert a cord into the tube end, and secure the cord with
plastic tape as shown.
Caution
4. Remove the antenna assembly by pulling it gradually.
Cord
Tape
Hole
Cord
Junction block
To Next Page
Loading...
