BODY ± Door
42-20
DEFECTIVE POWER WINDOW ADJUSTMENT
AND REPLACEMENT
If the window glass wrongly, automatically lowers while being
raised, adjust or replace as follows:
1. Remove the door trim and the waterproof film. (Refer to
P.42-23.)
2. Remove the window regulator assembly from the door
window glass, and then raise and lower the door window
glass by hand to check the operation force.
NOTE
Insert soft stuff like cushion to prevent damage to the
glass if it falls down.
3. If the door window glass does not move up and down
smoothly, do as follows:
D Check the installation condition of the runchannel.
D Straighten twist in the door sash.
D Check the installation condition of the lower sash or
the center sash.
NOTE
The lower sash cannot normally be adjusted, but it may
be possible to adjust the sash span slightly within the
range allowed by manufacturing tolerances by pushing
the lower sash outwards while re-installing it.
4. If repair or adjustment is impossible, replace the door
assembly.
POWER WINDOW SAFETY MECHANISM
CHECK
1. Place a wooden board about 10 mm thick as shown. Then,
raise the window glass.
2. Check that the window lowers by about 150 mm when
the window clamps the board. If this doesn't happen, do
troubleshooting. (Refer to GROUP 54B.)
DOOR OUTSIDE HANDLE PLAY CHECK
1. Measure the door outside handle play.
Standard value (B): 3.7 mm or more
2. If the play is not within the standard value, check the
door outside handle or the door latch assembly. Replace,
if necessary.
Runchannel
Door
sash
Lower sash
Section A ±
A
A
A
B
To Next Page
Loading...
