AUTOMATIC TRANSMISSION ± On-vehicle Service
23-49
2. If there is a problem on the inspection above, adjust the shift
lock cable as follows:
(1) Remove the rear floor console. (Refer to GROUP 52A.)
(2) Move the selector lever to P position.
(3) Loosen the shift lock cable fixing nut.
(4) Move the shift lock cable to position the shift lock
cable end above the red marking painted on the lock
cam, and then tighten the shift lock cable fixing nut
to the specified torque.
Tightening torque: 12 Nm
(5) Install the rear floor console. (Refer to GROUP 52A.)
TRANSMISSION CONTROL CABLE
ADJUSTMENT
1. Move the selector lever to N position, and set the
transmission lever to N position.
2. Loosen the fixing bolt. Adjust the adjuster lever position
so that the transmission control cable will be tight, and
then tighten the fixing bolt.
Lock cam
12 Nm
Shift lock cable
Red marking
N
Front of vehicle
Transmission
Transmission lever
90°C
Fixing bolt
Adjuster lever
Transmission
control cable
To Next Page
Loading...
