AUTOMATIC TRANSMISSION ± On-vehicle Service
23-48
2. If there is a problem on the inspection above, adjust the
key interlock cable as follows:
(1) Remove the rear floor console. (Refer to GROUP 52A.)
(2) Move the selector lever to P position.
(3) Turn the ignition key to LOCK (OFF) position.
(4) Loosen the key interlock cable fixing nut.
(5) Tighten the key interlock cable fixing nut to the specified
torque with the lock cam pushed in the direction A
(shown in the illustration).
Tightening torque: 12 Nm
(6) Install the rear floor console. (Refer to GROUP 52A.)
SHIFT LOCK MECHANISM CHECK
1. Carry out the following inspection:
Inspection
procedure
Requirements Normal condition
1
Brake pedal:
Depressed
Ignition key: ACC
If the selector lever push button is not pushed, the
selector lever can not be moved from P position.
2 If the selector lever push button is pushed, the
selector lever can be moved from P position.
3 Brake pedal:
Not depressed
If the selector lever push button is pushed, the
selector lever can be moved from R position to P
position.
A
Lock cam
12 Nm
To Next Page
Loading...
