FRONT AXLE ± Hub and Knuckle Assembly
26-14
HUB AND KNUCKLE ASSEMBLY
REMOVAL AND INSTALLATION
Post-installation Operation
Press the Dust Cover with a Finger to Check Whether
the Dust Cover is Cracked or Damaged.
7
3
196 ± 255 Nm
4
2
1
5
6
8
9
10
11
108 ± 127 Nm
59 ± 71 Nm
59 ± 71 Nm
90 ± 110 Nm
9 Nm
Removal steps
1. Disc brake assembly
2. Brake disc
3. Wheel speed sensor <Vehicles with
ABS>
4. Dust cover
AA" " AA 5. Castle nut
" AA 6. Washer
AB" 7. Lower arm and hub/knuckle
assembly connection
AB" 8. Tie rod end and hub/knuckle
assembly connection
AC" 9. Drive shaft and hub/knuckle
assembly connection
10. Strut assembly and hub/knuckle
assembly connection
11. Hub/knuckle assembly
REMOVAL SERVICE POINTS
AA" CASTLE NUT REMOVAL
Caution
Never apply the vehicle weight to the wheel bearing while
the castle nut is loosened. If the vehicle weight is applied,
the wheel bearing will be damaged.
MB990767
To Next Page
Loading...
