AUTOMATIC TRANSMISSION ± On-vehicle Service
23-39
HIGH/LOW DETECTION SWITCH CONTINUITY CHECK
Check the continuity between the terminal of the black
connector installed in the top of transfer case (shown in the
illustration) and the transfer case.
Transfer lever position Continuity
4HLc Continuity
Between 4HLc and 4LLc No continuity
4LLc Continuity
TRANSFER OIL CHECK
1. Remove the oil filler plug.
2. Check that the oil level is at the lower portion of the oil
filler plug hole.
3. Check that the oil is not noticeably dirty, and that it has
a suitable viscosity.
4. Tighten the oil filler plug to the specified torque.
Tightening torque: 29 ± 34 Nm
TRANSFER OIL REPLACEMENT
1. Remove the oil drain plug to drain oil.
2. Tighten the oil drain plug to the specified torque.
Tightening torque: 29 ± 34 Nm
3. Remove the oil filler plug and fill with specified oil till the
level comes to the lower portion of oil filler plug hole.
Specified oil:
Hypoid gear oil SAE 75W - 90 or 75W - 85W
conforming to API GL-4
Quantity: 2.2
4. Tighten the oil filler plug to the specified torque.
Tightening torque: 29 ± 34 Nm
Oil filler plug
hole
Oil level
Oil filler plug
Oil drain plug
To Next Page
Loading...
