FRONT AXLE ± Drive Shaft
26-19
DRIVE SHAFT
REMOVAL AND INSTALLATION
Caution
On the vehicles with ABS, when the drive shaft is removed or installed, be careful not to interfere
with the ABS rotor installed to the B.J. outer race to prevent the rotor from damage.
Pre-removal Operation
D Disengage the Stabilizer Link from the Strut Bar
(Refer to GROUP 33 ± Strut Bar and Lower Arm.)
D Brake Disc Removal (Refer to P.26-14.)
Post-installation Operation
D Press the Dust Cover with a Finger to Check
Whether the Dust Cover is Cracked or Damaged.
D Engage the Stabilizer Link with the Strut Bar (Refer
to GROUP 33 ± Strut Bar and Lower Arm.)
D Brake Disc Installation (Refer to P.26-14.)
<RH>
7
3
4
5
1
2
6
6
196 ± 255 Nm
59 ± 71 Nm
59 ± 71 Nm
<LH>
Removal steps
AA" " AA 1. Castle nut
" AA 2. Washer
AB" 3. Tie rod end and hub/knuckle
assembly connection
4. Wheel speed sensor
AB" 5. Lower arm and hub/knuckle
assembly connection
AC" 6. Drive shaft
7. Circlip
REMOVAL SERVICE POINTS
AA" CASTLE NUT REMOVAL
Caution
Never apply the vehicle weight to the wheel bearing while
the castle nut is loosened. If the vehicle weight is applied,
the wheel bearing will be damaged.
MB990767
To Next Page
Loading...
